| Availability: | |
|---|---|
| Quantity: | |
Fixed-position storage for a precision component is closer to fixture design than to packaging. The goal is not to wedge a part so it cannot move; it is to define where it sits, in the same attitude, every single time, without bending it. A part held by too many points may be perfectly immobile and subtly distorted—which is worse than useless when the surface being protected is a machined or optical one.
The layout starts from the part's datum scheme. Three support points define the primary plane, two points on a side face constrain rotation and lateral travel, and one point at an end fixes the last horizontal freedom. A lid or a light hold-down block takes the sixth. Each EPP block is moulded to the surface it meets—a flat pad for a machined base, a radiused face for a cast boss, a narrow land for a flange—so the contact is predictable rather than accidental.
Over-location is the mistake to design out. An extra block under a thin housing, or a cavity wall that touches a tolerance-high casting, introduces a force the part was never meant to carry. EPP's compliance forgives small variation, but forgiveness is not a substitute for correct geometry: relief is left around non-datum surfaces, and no block is placed where it could push a wall out of shape during weeks in storage.
Material selection follows the load at each point. Densities from roughly 15 to 100 kg/m³ and compressive strengths from 0.3 to 2.5 MPa let a locating block be stiff where position must be held, while a separate cushioning block stays softer to absorb handling shocks. Keeping those two jobs apart is what allows a fixture-like hold and real protection to coexist. Expanded polypropylene recovers above ninety-five percent after compression, absorbs under 0.3 percent water, and stays stable from −40 °C to 130 °C.
Blocks are then fixed into the container—bonded or clipped to a PP hollow-board panel or the crate floor—with positions tied to the datum drawing and identifiable by moulded numbering. If a part family changes, individual blocks are replaced rather than an entire liner scrapped. Block height and seat geometry are controlled so repeatability can be checked with a simple gauge on the first article.
Verification closes the loop: place a master part, measure its position at the defined datums, lift and reseat it twenty times, and confirm the readings stay within band. A storage insert that passes that test is doing what a fixture would do, at a fraction of the weight.
To have blocks designed, send the part model with its datum scheme, its weight, the surfaces that must stay clear, and the internal size of the box. The response should be a locating layout showing each point, its material grade, and the repeatability check—position defined by geometry, not by friction.