| Availability: | |
|---|---|
| Quantity: | |
A transport liner is designed around a drop. A storage liner is designed around a date. A part can sit on a rack for months and still come out with a flattened pocket, a dull patch on its coating, or a bond to the foam. Those are slow failures, and they are decided by the material grade and the contact conditions, not by cushioning performance in a drop test.
Compression set comes first. Under constant load a foam slowly loses thickness, so the clearance that held a part in week one grows into a rattle by month six. We choose a cross linked low set grade, keep preload small, and spread load over agreed support faces. Pocket depth is rechecked after a representative dwell, not only on a fresh sample.
Contact compatibility is the second. VA content, additives, and any plasticiser can migrate onto painted, plated, or optical surfaces during long contact, especially when a warm store and a sealed bag are involved. Sample liners are held against the real finish through temperature and humidity cycles, then examined for haze, colour transfer, and sticking. A film barrier ply is added where the test shows any doubt.
The store sets the rest. Closed cell EVA absorbs very little water, but condensation still settles on a cold part, and dust collects on a horizontal foam face over a long shutdown. Lids, sleeves, and a desiccant keep the cavity clean, while a shaded rack avoids surface ageing from direct light. The agreed storage window and conditions are printed on the label.
Retrieval after months differs from retrieval on a packing line. Long compressed foam feels firmer at the lip, so finger notches are generous, edges rounded, and cut surfaces sealed. Each liner carries the part number, the packing date, and the reinspection date, so a store can rotate stock and see at a glance what is due for a check.
Reinspection is short and repeatable. At the stated interval the crate is opened and the pocket, contact faces, and label are checked against the first article record. A liner with a permanent set, a mark on the part, or an expired storage window is replaced on its own. Where the same pack later goes into transport, the drop and vibration requirements are verified again rather than assumed.
To specify a liner for storage, send the part drawing with its surface materials, the expected storage duration, temperature and humidity range, racking or stacking method, whether the crate is sealed, the reinspection interval, and any later transport leg. We return a material grade with compression set evidence, a contact compatibility report, a labelled storage instruction, and sample liners for a dwell trial.