| Availability: | |
|---|---|
| Quantity: | |
Bulk transport asks a different question from precision packaging. Nobody needs a unique pocket for every fastener, clip, or stamped bracket; what matters is that a crate holds a known quantity, that layers stay separate, that an operator can reach in without jamming a hand, and that empty trays come back cheaply. The tray is a measuring and flow device, not a contour exercise.
Capacity comes before geometry. Part size, how parts settle, target count per crate, and crate inner dimensions set the footprint and fill height. We leave enough clearance for a loaded layer to settle without binding, but not enough for parts to migrate across the tray. A moulded fill line inside the wall makes the correct quantity visible at a glance. The line is moulded, not printed, so it survives washing.
Layers do the real work. A fixed count per layer over a known number of layers turns counting into a visual check. Layer pads sit on moulded ledges so they cannot slide sideways in transit, and they spread the weight of upper layers across the tray wall rather than onto the parts below. The ledges also stop a filled stack settling into a wedge.
Access follows the line, not the drawing. A lowered wall or lead in ramp lets parts tip into a line side bin, and rounded corners clear both a gloved hand and a coated part. No dead pocket may trap the last pieces and slow down the shift. The label zone sits on the face the operator actually sees.
HDPE is chosen for the route, not the datasheet. It keeps impact strength in cold stores and winter yards, resists the oils and cleaning agents a parts loop uses, and tolerates repeated washing without whitening at the corners. Wall thickness is measured at the floor and corners of a trial tray, and a static dissipative grade is available where electronic modules share the crate.
Empty trays must behave as well as full ones. A small release angle and a flange step let them nest without wedging, and the smooth surface washes and dries between trips. Batch colour marks and a moulded identification field keep one programme's trays with its own parts, while a separate small compartment holds the remainder of an opened batch so two lots never mix.
To specify, send the part dimensions and weight, surface finish requirements, target count per crate, parts per layer, how the line takes parts out, the crate inner dimensions, stacked layer count, cleaning agents, temperature range, and expected cycles. We return a capacity calculation, a layer pad drawing, and sample trays for a fill, count, tip out, and wash trial before tooling.