| Availability: | |
|---|---|
| Quantity: | |
"Perfectly conforms to the shape of the product" is a claim that belongs on a drawing, not only in a brochure. In automotive component storage, the fit between a part and its cavity decides whether the part stays put through months of handling or slowly works itself loose. That makes conformity something to be designed with numbers and verified on a first article, not an adjective a supplier applies after the tray is moulded.
The first thing to understand is that a good fit is selective. A cavity should not cling to every surface of a part. Contact faces are chosen deliberately—cast ribs, mounting flanges, unmachined bosses—where the load can be carried safely. Everywhere else, relief zones are cut back: painted faces, sealing surfaces, optical finishes, and sharp edges sit clear of the formed wall. A tray that touches everything is usually a tray that marks something, and a part wedged into full-surface contact is a part nobody can lift out.
Between those two regions sits a clearance band. Cavity dimensions are set against the measured part, not only its nominal CAD, with allowance for the component's own manufacturing tolerance and for the shrinkage of the formed sheet. Too tight and a hot part or a tolerance-high casting jams in the pocket, encouraging operators to force it; too loose and vibration finds the gap. The band is stated on the drawing so it can be checked later instead of judged by feel.
Verification is what turns the claim into evidence. On the first article, pressure-indicating film or a simple contact-transfer check shows where the part actually bears and where it floats. A 3D scan of the formed cavity is compared with the approved model, and feeler gauges at defined points confirm the clearance band. A loaded tray then goes through a short handling and vibration trial, after which the part is inspected for witness marks. The result is a fit report tied to that tool revision.
Conformity also has to serve the person packing the box. Finger recesses, draft angles on the cavity walls, and local relief at the lifting points let a gloved operator take a part out in one motion without prying against a finished edge. Fit is judged as much by that motion as by a measurement.
Because parts and tools both change, the check is repeated. A drawing revision, mould wear, a different sheet batch, or a new forming temperature all warrant a fresh first article and an updated report. Keeping the sample and the record together means a quality team can always match a tray to the part revision it was built for.
To have conformity specified properly, supply the part model or a scan, its tolerance range, the surfaces that must stay untouched, and how operators lift it. The response should be a contact and relief layout, a clearance band, and the verification results—proof that the tray fits the part that actually arrives, not the one on the catalogue page.